How to fix slow Wi-Fi at home: find the bottleneck, then fix it
Slow Wi-Fi is usually distance, walls, a hidden router or one device hogging the airtime, not the nbn plan. Start by testing wired against wireless to find where the slowdown is, then work through placement, device settings, security mode and channels before you spend anything on new gear.
- Moderate
- 20 to 45 minutes
- 4 min read
Rather we fix it? Usually a single visit at our Mitchell workshop, with a fixed quote first.
Open 7 days, 9 am to 8 pm“Very personable and professional attention to the problem. Would use again.”
Key takeaways
- Test wired, beside the router and in the slow room before you change anything. It tells you whether it's the Wi-Fi or the connection.
- Router placement is free and often the biggest single improvement: high, central and out of cupboards.
- Old security modes such as TKIP cap the Wi-Fi link at 54 Mbps, however strong the signal.
- Plug-in extenders usually halve the speed. Mesh nodes placed halfway to the slow room, ideally wired together, fix far rooms properly.
Rather we just fix it?
Wi-Fi in every room, the granny flat and the deck, designed from measurements of your actual house.
Wi-Fi and mesh1300 224 027Try these fixes, in order
Start at the top. Most problems are solved in the first few steps. Tick them off as you go.
Where is the slowdown?
When and where it's slow points to the cause. Match your pattern to a row.
Not sure which one it is? Send us the symptoms and we’ll tell you before you travel.
Tried these and still stuck?
Leave your number. A technician calls back 9 am to 8 pm, 7 days, and tells you whether it’s worth bringing in before you travel.
What the repair looks like
Drag the handle to compare. This kind of fault, before and after on the bench.

- wired, beside the router, in the slow room: where to start
- 3 tests
- the standard 2.4 GHz channels, so yours doesn't overlap neighbours'
- 1, 6 or 11
- the link-rate cap when a router uses old TKIP security
- 54 Mbps
- where a mesh node belongs, between router and slow room
- Halfway

Wi-Fi in every room
Where mesh nodes go in a typical Canberra home.
- RouterMoved out of the cupboard where possible.
- Mesh nodesOne per floor or zone, ideally wired back.Drawn in red: where we focus first
- Brick and foilThe walls that block signal in older homes.
- Outdoor reachGranny flats, studios and the backyard.
Why Wi-Fi gets slow
Wi-Fi is radio, and every wall, floor and appliance takes a bite out of the signal.
As it weakens, router and device drop to slower link rates, so a phone two rooms away gets a fraction of the speed it gets beside the router.
Building materials matter more than distance.
| Material | Effect on Wi-Fi |
|---|---|
| Plasterboard and timber | Barely slows it down |
| Brick veneer | Costs more |
| Double brick, concrete slabs, mirrors, fish tanks, the fridge | Cost a lot |
Read more
Canberra has plenty of all of it: solid double brick in older homes across the inner north and inner south, and foil sarking, foil-faced insulation and Low-E double glazing in newer Gungahlin and Molonglo builds, which reflect Wi-Fi as well as heat. In many new estates the nbn connection box went in the garage, so the router starts at the worst end of the house.
Ways to fix a slow room compared
From free to a proper install. Start on the left and move right only if testing says you need to.
Swipe to compare
| Move the router | Plug-in extender | Mesh, wireless backhaul | Our pickMesh or access points, wired | |
|---|---|---|---|---|
| Cost | Free | Low | Mid | Mid to high |
| Speed in the far room | Better, if it was boxed in | Often half the router's | Good with a tri-band system | Close to full speed |
| One network name | Partial | |||
| Copes with double brick | Partial | |||
| Devices hand over as you move | Not needed | Partial | ||
| Cabling needed | None | None | None | A cable path to each unit |
| Best for | Every home, as step one | One small dead spot, as a stopgap | Most brick-veneer homes | Double brick, two storeys, granny flats |
Wired backhaul is the biggest single upgrade to any mesh system. Where there's no cable path, a tri-band mesh is the next best thing.
2.4, 5 and 6 GHz compared
Most routers broadcast more than one band under one name. Knowing what each is good at explains a lot of slow-Wi-Fi puzzles.
Swipe to compare
| 2.4 GHz | 5 GHz | 6 GHz | |
|---|---|---|---|
| Range through walls | Longest | Medium | Shortest |
| Speed | Slowest | Fast | Fastest |
| Crowding from neighbours | Heavy | Moderate | Light |
| Works with | Every Wi-Fi device | Nearly everything from the last decade | Wi-Fi 6E and Wi-Fi 7 devices only |
| Best for | Smart plugs, cameras, far corners | Phones, laptops and TVs | Same-room speed and mesh backhaul |
| Channel advice | 1, 6 or 11, at 20 MHz | Automatic, at 80 MHz | Automatic |
Don't switch 2.4 GHz off to force devices onto 5 GHz. Smart-home devices need it, and it's the band that reaches the far rooms.
The numbers that matter
The link speed your device shows is the raw rate negotiated with the router, not what you’ll get. Real throughput is usually half to two-thirds of it.
Link speed
A phone linked at 1,200 Mbps beside a Wi-Fi 6 router might test at 600 to 800 Mbps. Two brick walls away, it might link at 150 Mbps and test well under 100.
Your plan
Since nbn’s September 2025 speed upgrade, many FTTP and HFC plans deliver several hundred megabits per second, more than an older Wi-Fi 5 router can carry to the next room. The plan got faster and the Wi-Fi quietly became the bottleneck.
Upload
Nbn plans have far less upload than download. When a cloud backup or security camera fills it, everything lags, video calls included. Gamers feel it as lag spikes, which network engineers call bufferbloat.
Deeper checks
If the fixes on this page haven’t found it, these tools show what’s happening in the air.
Windows
Open Terminal and run netsh wlan show interfaces. It lists the channel, the radio type (802.11ax is Wi-Fi 6), the receive and transmit rates, and the signal as a percentage. Below about 60 per cent, expect speeds to fall away.
Mac
Hold Option and click the Wi-Fi icon. RSSI is signal strength: around -67 dBm or stronger suits smooth video calls, and below about -75 dBm gets unreliable. The same menu opens Wireless Diagnostics, whose Scan window lists nearby networks and their channels.
Android
A free Wi-Fi analyser app graphs every network around you by channel, showing at a glance whether your 2.4 GHz channel is shared with half the street.
Your router's app
Most show each connected device, its band and signal, and which ones are using the most data right now.
Tip: Walk the house with a phone and a speed test app, noting each room. Where speeds fall off a cliff, you need a mesh node or access point; our mesh Wi-Fi guide explains how to choose and place them.
What not to do

Each of these either fails to fix slow Wi-Fi or creates a new problem. Avoid them.
- Don’t buy a faster plan first. If the wired test is fine, a faster plan only makes the gap bigger.
- Don’t daisy-chain extenders. Each single-radio hop roughly halves the speed and adds another network for devices to cling to.
- Don’t run two routers in a row. Behind your provider’s modem, put one in bridge or access point mode. Double NAT causes trouble with gaming, video calls and smart-home apps.
- Don’t factory reset without your provider’s details. A reset can wipe the username and password some providers need, leaving the whole house offline.
- Don’t mix mesh brands. Nodes generally only work together within one product range.
- Don’t hide the router. TV cabinets, cupboards, the floor behind the couch and its own tangle of cables all cost speed.
When to call us
If the wired test is fast and the Wi-Fi is still slow, the house needs better coverage, not more settings. If the wired test is slow, the connection is the problem: talk to your provider.
- Measure. We check the speed arriving at your nbn connection.
- Map. We map the signal room by room.
- Design. The smallest setup that covers the house: a better-placed router, mesh with wired backhaul where there’s a cable path, or ceiling access points for larger and double-brick homes.
- Wi-Fi and mesh installationCoverage designed and installed for your house
- Router setupWhen the router itself is the weak link
- TechBox InternetCustomers call 1300 224 027 and we’ll check the connection
- Choosing an nbn plan in CanberraWhat each connection type can realistically deliver
- How to fix Wi-Fi dropoutsWhen it drops out rather than slows
- Business networks and Wi-FiOffices where dozens of devices share airtime
Home visits are $189 for the first hour, then billed in 30-minute blocks. We’re open 7 days, with calls answered until 8 pm.
Common questions
Still stuck? Call 1300 224 027, 9 am to 8 pm, 7 days.
Why is my Wi-Fi slow when the speed test on my computer is fine?
If the computer is plugged into the router by cable, it's measuring the connection, not the Wi-Fi. Wi-Fi speed falls with distance and every wall in the way. Run the same test over Wi-Fi beside the router and in the slow room: if only the far rooms are slow, it's a coverage problem.
Will a faster nbn plan fix slow Wi-Fi?
Only if a wired test is slow too. If the wired speed is fine and the Wi-Fi isn't, a faster plan just widens the gap. Fix the coverage first, then decide whether you need more speed. Our guide to choosing an nbn plan covers the plan side.
Do Wi-Fi extenders work?
They help with one small dead spot, at a cost. Most plug-in extenders use the same radio to listen and repeat, which roughly halves the speed, and many create a second network your devices cling to. A mesh system does the same job far better.
Is my provider's modem the problem?
Sometimes. Provider modems range from good to basic, and older ones are often Wi-Fi 5. You can usually keep it as the modem and let a mesh system run the Wi-Fi, with one of them in bridge or access point mode so you don't have two routers doing the same job.
Why is my Wi-Fi slower at night?
There are two common reasons. Your provider's network may be busy in the evening, which shows up on a wired test too. Or your Wi-Fi channel is crowded by neighbours' networks and your own household's streaming, which only shows on Wi-Fi. A wired test at 8 pm tells you which.
Should I turn off 2.4 GHz to make my Wi-Fi faster?
No. Smart plugs, cameras and many appliances only use 2.4 GHz, and it reaches further than 5 GHz. Modern routers steer capable devices onto the faster bands on their own. If a device keeps clinging to 2.4 GHz beside the router, check its connection details and update it.
How often should I restart my router?
There's no need to do it on a schedule. A restart clears a router that's stuck, but if yours needs one every few days, it's overheating, out of date or failing. Update its firmware, check it has airflow, and consider replacing it if it's several years old.
Can you check my Wi-Fi at home?
Yes. On a home visit we test the speed arriving at your nbn connection, map the signal room by room and tell you what's limiting it. Visits are $189 for the first hour, then billed in 30-minute blocks, and we're open 7 days.
Repairs for this problem

Wi-Fi and mesh
Bedrooms with one bar, a granny flat that can't get a signal, a smart TV that buffers every evening.

Router setup
A new router still in its box, a modem your provider just posted, or an old one that's never been touched since the NBN went in.

TechBox Internet
TechBox Internet is our own NBN service, running on the Superloop network and backed by our local team.
Reviews from TechBox customers
Real Google reviews.
Duvi was excellent, very quick to identify my needs and to fix issues. Very Knowledgeable about Apple and Macintosh products . A very smart and focussed technician . I am very happy with his serviced happy to recommend him to anyone whinnied tech help.
Tech Box saved the day!!!!!!!!!!! With my laptop on the brink of despair, I turned to Tech Box for help, and they delivered beyond expectations. Their expert team swiftly diagnosed and resolved the issue, displaying a level of professionalism that's truly commendable.
Very personable and professional attention to the problem. Would use again.
Still not fixed? We’ll take it from here
Call now, or send a ticket and we’ll call you back with a time and a price range. Drop it at Mitchell or we come to you.
1300 224 027Calls answered 9 am to 8 pm, 7 days.
- Quote before any work starts
- Workshop in Mitchell, visits across Canberra
- If something isn’t right, we come back and make it right.
“Great friendly service, on time to solve the problem”


